Universal Electronics OCAP 5 Manual do Utilizador descarregar pdf (Página 13)

www.urcsupport.com/atlasocap

7. To search for the codes of your other devices,

repeat steps 1 through 6, but substitute the

appropriate key (e.g., VCR, DVD, AUD, or CBL)

for the device you are searching for.

CHECKING THE CODES

If you have set up the Atlas OCAP 5-Device Remote

Control by searching for your device code (on the

previous page), you may need to find out which four-

digit code is operating your equipment.

or example, to find out which code is operating your TV

4. Aim the remote control at the TV and press

PWR once.

5. Press and release the CH+ key continuously,

then stop when the TV turns off.

NOTE: In the search mode, the remote control will

send IR codes from its library to the selected

device, starting with the most popular code

first.

6. Press PWR. The TV should turn on, then press

SETUP to lock in the code.

NOTE: If the TV does not turn on during step 6, then

slowly press and release CH- to go back

through the codes, then press SETUP when the

TV turns on.

1. On the remote control, press TV once; it will

blink once. Then press and hold SETUP until

the TV key blinks twice.

2. Enter 9 9 0. The TV key will blink twice.

3. To view the code for the first digit, press 1

once. Count the number of times the TV key

blinks (e.g., 3 blinks = 3) and write down the

number in the leftmost TV Code box on

page 11.

NOTE: If a code digit is 0, the selected mode key will

not blink.

Atlas OCAP M1056.fm Page 13 Tuesday, March 24, 2009 4:45 PM

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 87 88

Sem comentários

Universal Electronics OCAP 5 Manual do Utilizador Página 13