Universal Electronics CONTROL 2 Guia do Utilizador descarregar pdf (Página 23)

PROGRAMMING CHANNEL CONTROL LOCK

By default,the remote control’s channel-control capabilities

are locked to the cable converter. The affected keys* are

0~ 9,CH+, CH-,ENTER,and LAST.This will guarantee that

you do not inadvertently change a channel on your TV or

VCR. However, you can de-activate this feature to allow full

access to these keys in the TV and VCR modes.

*NOTE: This feature does not affect the AUD mode.

To De-Activate Channel Control Lock:

1. On the remote control,press CBL once.

Then press and hold SETUP until the

CBL key blinks twice, then release SETUP.

2. Enter 9 -7- 3.The CBL key will blink two times.

3. Press CH- once. The CBL key will blink

four times.

4. Now, the remote control will provide TV and

VCR channel-control capabilities while in the

TV or VCR mode.

To Re-Activate Channel Control Lock:

1. On the remote control,press CBL once.

Then press and hold SETUP until the

CBL key blinks twice, then release SETUP.

2. Enter 9 -7- 3.The CBL key will blink two times.

3. Press CH+ once. The CBL key will blink twice.

4. Now, regardless of what mode you select

(i.e., TV, VCR,or CBL), only the channel

control capability of your cable converter will

be accessible.

Atlas Manual rev2 12/27/02 11:07 AM Page 23

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 31 32

Sem comentários

Universal Electronics CONTROL 2 Guia do Utilizador Página 23